REPLACEABLE SINGLE SHOOT TIPS
We partner with Leth Iron in Lethbridge, AB to cast our replaceable carbide tips, providing Canadian made products with superior wear resistance.
All tips on this page use bolt and nut combo 200-BNC-3100.
“We are using a 3/4 inch opener. Penetration is very good, long-lasting. Minimum stepping.”
Bernie Klammer, Vegreville, AB
CARBIDE TIP
1/2″ (13mm) with carbide insert on the nose. Not recommended in highly abrasive conditions.
CHROME TIP
3/4” (19mm) tip. Not recommended in highly abrasive conditions.
CARBIDE TIP
3/4” (19mm) tip with carbide insert on the nose.
CARBIDE TIP
3/4” (19mm) tip with extra long carbide on the nose for highly abrasive conditions.
CARBIDE TIP
3/4” (19mm) tip with extra long carbide on the nose and sides for highly abrasive conditions. The same as 200-TIP-0802 but with the addition of the side carbide inserts.
VERTICAL CARBIDE TIP
3/4” (19mm) vertical tip with extra long carbide on the nose for highly abrasive conditions.
VERTICAL CARBIDE TIP
1” (25mm) vertical tip with double carbide insert. Recommended for rocky and highly abrasive conditions.
CARBIDE TIP SPREAD
2” (51mm) tip with carbide insert on the nose to fracture the ground. Carbide inserts on the underside of the wings to maintain a sharp cutting edge.
CHROME SPREAD TIP
3” (76mm) tip. Not recommended in highly abrasive conditions.
CARBIDE SPREAD TIP
3” (76mm) tip with carbide insert on the nose and hard facing on the underside of the wings.
CARBIDE SPREAD TIP
3” (76mm) tip with carbide insert on the nose to fracture the ground. Carbide inserts on the underside of the wings to maintain a sharp cutting edge.
CARBIDE SPREAD TIP
4” (102mm) tip with carbide insert on the nose to fracture the ground. Carbide inserts on the underside of the wings to maintain a sharp cutting edge.
CARBIDE SPREAD TIP
3/4” (19mm) long-wearing single shoot tip with extra long carbide on the nose for high abrasive conditions. Used for seeding or fertilizing (not for double shooting).